Converts reciprocating motion into rotary motion — 2nd inversion of the slider-crank chain (crank fixed)

Overview

The rotary IC engine uses a fixed crank (Link 2) connected to a piston (Link 3) through a connecting rod (Link 4). The whole cylinder block (Link 1) rotates about the shaft centre, while each piston reciprocates inside its rotating cylinder.

Used in early aircraft (Gnome, Le Rhône) — the propeller was bolted to the spinning cylinder block itself.

Kinematics

With crank pin A fixed at eccentricity e from centre O, the piston in a cylinder at block angle ψ sits at

u(ψ) = e·cos ψ + √(L² − e²·sin²ψ)

measured from O along the cylinder axis — the same slider-crank law, viewed from the rotating frame. Stroke = 2e.

① INTAKE
② COMPRESSION
③ IGNITION
④ POWER
⑤ EXHAUST
⑥ INTAKE
⑦ COMPRESSION
⑧ POWER…

Components (Links)

1Cylinder block — ROTATES about O
2Crank O–A — FIXED to the frame
3Pistons — slide in rotating cylinders
4Connecting rods — all pinned at A

Live Data

Block angle ψ
0°
Cyl-1 stroke
—
Piston travel 2e
— mm
Cyl-1 position u
— mm
Firing / rev (4-str)
—
Rod / throw L/e
—
Why odd N? With a 4-stroke cycle spanning two revolutions, an odd cylinder count lets alternate cylinders fire at equal intervals — smooth, continuous power.
🔄Reciprocating → rotary motion
🎯Smooth, compact, low vibration
✈Aircraft engines
🚗Automobiles & generator sets
🛵Small engines
🚁Drones & UAV concepts